Radian-technologies VT R800 7040 00 Manuel d'utilisateur télécharger pdf (Page 6)

True to the Music

Radial Engineering Headbone Owner’s Manual

FEATURE SET

1. Input Buffered – This is the primary input for your guitar and pedal

effects that do not buffer (pre-amplify) the signal.

2. Input Direct – Used when driving the Headbone from a device, like

the Radial Loopbone, that buffers (pre-ampliﬁes) the signal.

3. To Amp-1 Input – This is a ¼” hi-impedance guitar signal output that

connects from the Headbone to the input of the ﬁrst guitar ampliﬁer.

4. To Amp-2 Input – This is a ¼” hi-impedance guitar signal output

that connects from the Headbone to the input of the second guitar

ampliﬁer.

5. Ground Lift – This recessed switch connects the ground to Amp-2. This

switch is factory set in a ‘lifted’ position to eliminate ground loops.

6. Slingshot Remote Input – This ¼” input is used to remotely control the

Headbone from your pedalboard using a standard contact closure foot-

switch or another Tonebone device that features a Slingshot output.

7. From Amp-1 Output – Connects from the ﬁrst ampliﬁer’s speaker

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Pas de commentaire

Radian-technologies VT R800 7040 00 Manuel d'utilisateur Page 6